F4 Advanced Flight Controller – (MPU6000, STM32F405)



This is a next gen. flight controller featuring the STM32F405 processor and MPU6000 gyro. The advanced F4 processor gives this FC incredible precision and control while in the air. This flight controller includes 3 UART connections with SBUS, PPM or Serial RX and has a 3.3v output for Spektrum receivers as well as a hardware boot button. The board has been designed around the popular CC3D Revolution target and is fully support by RaceFlight, BetaFlight and CleanFlight. It comes preloaded with BetaFlight firmware.

In stock

SKU: F4FCAD Categories: ,


  • Weight: 5g
  • 36mm x 36mm (standard 30.5mm between mounting holes)
  • Support raceflight and betaflight firmware, default is BF.
  • Use MPU6000 accelerometers and gyroscopes
  • Gyro and MCU have 3.3V independent power supply
  • Support LED strip and blackbox
  • Has outputs for up to 6 motors (ESCs)
  • Three available hardware UART ports
  • Built in inverter for SBUS input
  • STM32F405 32-bit processor at 168MHz, 1Mb flash, 192kb ram
  • Micro USB connectivity using STM Virtual Communications Port
  • M25P16 16 Mbit, serial Flash memory, 75 MHz SPI bus interface
  • 1x7pin JST-SH socket (SUBS,SERIAL,RX,TX,5V,GND)
  • 6X3pin though-holes for pin headers for ESC
  • No BEC
  • Input voltage: 5 ~ 8.4V
  • Firmware target: REVO / CC3D Revolution


  • 1x F4 Advanced Flight Controller – (MPU6000, STM32F405)
  • 1x 1×7 pin header straight
  • 1x 3×6 pin header straight
  • 1x 3×6 pin header right angle

Additional information

Weight .625 lbs
Dimensions 3 x .25 x 3 in